Connecting By Usb Interface - Renesas PC7501 User Manual

PC7501 User's Manual

4.2.2 Connecting by USB Interface

IMPORTANT
We do not ensure the operation in every combination with host machine, USB device, and USB hub.
The procedure to set up your system using the USB interface is shown below.
Turn OFF the power to the emulator PC7501.
Set the interface selection switch on the rear panel to "USB."
3.2.1 Interface Selection Switch (P.22)
T T
Connect the USB interface cable to the USB port of the host machine.
Figure 4.4 Connecting the USB interface cable (host machine side) (P.30)
T T
Connect the cable to the USB interface connector on the emulator PC7501.
Figure 4.5 Connecting the USB interface cable (emulator PC7501 side) (P.30)
T T
Connect the emulation probe M3xxxxTx-EPB or R0ExxxxxxEPB00 to the connector on the emulator
PC7501.
4.3 Connecting Emulation Probe M3xxxxTx-EPB or R0ExxxxxxEPB00 (P.35)
T T
Connect the emulation probe M3xxxxTx-EPB or R0ExxxxxxEPB00 and the target system.
See the user's manual of the emulation probe
T T
Turn ON the power to the host machine and then turn ON the power of the PC7501 and the target
system as simultaneously as possible.
R20UT0207EJ0500 Rev.5.00
Nov 01, 2010
4. Setup
Page 29 of 50