5.1.4.
Connecting the particulate matter probe
1
1 Transport securing device
2 Rubber ring
1. Open the transport securing device (1) and rubber ring (2).
2. Take the particulate matter probe cable out of the storage
compartment.
Always connect the particulate matter probe prior to
switching on the testo 380. The particulate matter probe is
detected during the testo 380 activation process.
The particulate matter probe will not be detected by the
testo 380 if it is not connected until after the testo 380 has
been switched on or if it is disconnected from the testo 380
during a measurement. The particulate matter probe will
only be detected once the testo 380 has been switched on
again.
5 First steps
27