How To Install The Wall Mount Bracket - Yamato DP-5601 Operation Manual

How to install the wall mount bracket

Installation procedure
1. First, remove the 4 set screws
of the indicator. Then install the supplied 2 wall
mount brackets by firmly tightening the 4
screws (make sure to insert the 4 washers
between the indicator and the 2 wall mount
brackets ).
2. Install the 2 wooden tapping screws
wall or post, as shown in the following figure.
105 mm (installation pitch)
3. Using the upper holes of the 2 wall mount
brackets set in the above step 1, hook the
brackets onto the 2 wooden tapping screws
set in the above step 2. The installation is now
complete.
Wall or post
<Caution>
on the back Since the 4 set screws
fixed torque at the factory, the enclosure is
water-proof and dust-proof (i.e. IP66 protection
rating), easy to wash, and hygienically sound
(HACCP compliance). However, for the wall-mount
type indicators, the user must remove the set screws
to a and then install the wall mount brackets
Therefore, the "IP66" and "HACCP compliance"
cannot be assured if the set screws
tightened or if the wall mount brackets
externally installed.
5
have been tightened to a
.
are not firmly
are