Yamato DP-5601 Operation Manual page 27

Note: Proper use of the instrument does not cause generation of errors.
If any of the above error codes is displayed, carry out the respective Corrective actions.
If the problem persists even after the above measures are taken, the instrument has internal
failure. Contact your dealer from which you purchased the instrument.
If "E-101" or higher number of error codes shows up, contact the dealer.
<When the optional RS232C is in
use>
This code appears when an
inexecutable command is received.
For example, an addition command is
received when there are no objects
placed on platform of the instrument.
<When the optional RS232C is in
use>
This code appears when an undefined
ZS99 command is received.
<When the optional RS232C is in
use>
This code appears when the
transmitted data length is too long.
<When the optional printer is in use>
This code appears when the call
number is "0" although the summary
setting for individual call numbers is
enabled.
<When the optional USB flash drive
feature is used>
This code appears when a USB flash
drive for writing is not connected.
<When the optional USB flash drive
feature is used>
This code appears when there is no
free space left in the USB flash drive
for writing.
<When the optional USB flash drive
feature is used>
This code appears when the USB
flash drive for writing has been set to
read only.
<When the optional USB flash drive
feature is used>
This code appears when the writing
time into the USB flash drive is too
long.
25
Check the specifications/status
of the instrument. Make the
instrument ready for the
command and then transmit
the command.
Press the key to reset the
error and then restart
communication.
Check the data transmitted by
the connected equipment.
Press the key to reset the
error and then restart
communication.
Check the data transmitted by
the connected equipment.
Press the key to reset the
error and then restart
communication.
Press the key and set the
call number. Then restart
weighing.
Check that a USB flash drive
has been inserted.
Press the key to reset the
error and then restart
communication.
Check the free space of the
USB flash drive.
Press the key to reset the
error and then restart
communication.
Check that the USB flash drive
is set to read/write.
Press the key to reset the
error and then restart
communication.
Check the data to be written in
the USB flash drive.
Press the key to reset the
error and then restart
communication.