Input Mode Display; Input Signal Display; Input Mode When Playing Cd Sources; Input Mode When Playing Dts Sources - Denon ADV-M71 Operating Instructions Manual

ENGLISH
3 Either turn the SURROUND/SELECT dial or press the
SURROUND button on the remote control unit to select the
surround mode.
SURROUND / SELECT
PUSH - PARAM.
Main unit
• The function switches as shown below.
• The function only changes in the "Æ" direction when
operated from the remote control unit.
DOLBY VS
*5CH STEREO
JAZZ CLUB
DOLBY VS
• The modes marked "*" can be selected when "5.1-
channel surround" is selected in the quick system setup.
4 Start playback on the selected component.
• For operating instructions, refer to the component's
manual.
5 Either turn the MASTER VOLUME dial on the main unit or
use the VOLUME buttons on the remote control unit to
adjust the volume.
M.VOLUME -20
• The volume can be adjusted within the range –60 to 0 to
+18 dB. Note that depending on the input signal, surround
mode, speaker settings and channel level setting, it may
not be possible to adjust the volume up to +18 dB.
2 To check the currently playing program source, etc.
Press the MENU/SET button. Display "STATUS" then turn
the SURROUND/SELECT control.
MENU / SET
Main unit
To perform this operation on the remote control unit, press
the STATUS button.
The current program source and surround settings are shown
on the display each time the button is pressed or turned.
(When the function is set to DVD, the information is also
displayed on the TV screen.)
44
SURROUND
Remote control unit
STEREO DIRECT *AUTO DECODE
*MONO MOVIE ROCK ARENA
VIDEO GAME *MATRIX
The volume level is displayed
on the display.
+
VOLUME
-
Main unit Remote control unit
SURROUND / SELECT
STATUS
PUSH - PARAM.
Main unit Remote control unit

Input mode display

• In the AUTO mode
• In the DIGITAL PCM mode
• In the DIGITAL DTS mode
• In the ANALOG mode

Input signal display

• DOLBY DIGITAL
• DTS
• PCM
• "DIG" lights when digital signals are input properly. If "DIG" is
flashing, check whether the connections are proper and whether
the input component's power is on.

Input mode when playing CD sources

• When playing CDs containing recordings of live concerts, etc., in
the "AUTO" mode, the sound may be slightly broken at the
beginning. If this happens, switch to the "PCM" mode.

Input mode when playing DTS sources

• If DTS-compatible CDs are played in the "PCM" mode, noise is
output because DTS playback is not possible.
To play a DTS-compatible source, be sure to set the input mode
to "AUTO" or "DTS".
• Noise may be generated at the beginning of playback and while
searching during DTS playback in the AUTO mode. If so, play in
the DTS mode.
Lit
One of these lights, depending on
the input signal.