Setting Up The System; System Setup Items; Playback - Denon ADV-M71 Operating Instructions Manual

10 SETTING UP THE SYSTEM

(1) System setup items

• Once all connections with other AV components have been completed as described in "CONNECTIONS" (see pages 8 to 15), make the various
settings described below on the monitor screen using the ADV-M71's on-screen display function.
• Use the following buttons to set up the system:
6
3
SETUP
CH SELECT
RETURN
Quick set up Set the screen size and the speaker system.
Input the combination of speakers in your system and
their corresponding sizes (SMALL for regular speakers,
Speaker Configuration LARGE for full-size, full-range) to automatically set the
composition of the signals output from the speakers and the
frequency response.
This parameter is for optimizing the timing with which the
Delay Time audio signals are produced from the speakers and subwoofer
according to the listening position.
At the listening position, listen to the test tones output
Channel Level from the different speakers and set so that the playback
level from the different speakers is equal.
The power automatically switches to standby if no
DVD auto power off setting operation is performed for 30 minutes while in the stop
mode with the function set to DVD.
Set the LINE-1 and LINE-2 function names and turn the
Function Setting
analog recording output (REC OUT) on or off.
Set the audio language, subtitle language and disc menu
Disc Setup
language for when playing discs.
OSD Setup Set the wallpaper for the setup and operation screens.
Video Setup Set the screen size and video system for the TV being used.
Set the digital audio signal format and the linear PCM
Audio Setup
sampling frequency and bit conversion.
Make the playback restriction setting for DVDs with
Ratings restricted viewing and set the password required for
changing the setting.
Make the closed caption setting for DVDs. (A commercially
Other Setup
available decoder is required to display the closed captions.)
SYSTEM SETUP button
Press this to display the system setup menu.
-
7
STATUS
MUTING
TONE /SDB
CURSOR buttons
1 and
ENTER
• and ª: Use these to move the cursors ( • and ª) to the up
SURROUND
PARAMETER
+
-
VCR CH
ENTER button
DISPLAY MENU TOP MENU
Press this to switch the display.
ANGLE AUDIO SUB TITLE
Also use this button to complete the setting.
System setup items and default values (set upon shipment from the factory)
Setup
:Use these to move the cursors (
0
on the screen.
and right
and down on the screen.
TV Aspect
4:3 PS
Front Sp. Center Sp.
Small
Sw Freq. = 150 Hz / SW mode = None
Front & Subwoofer
9ft (2.7m)
Front L Center
0 dB "__"
power does not turn off automatically
LINE-1
MD
Dialog
English
TV Aspect
4 : 3 PS
Digital Out
Normal
Rating Level
No Limit
Closed Caption
OFF
) to the
1 and 0 left
Default settings
Speaker
2CH Virtual & SW
Surround Sp. Sub Woofer
"__" "__"
Center
"__"
Front R Surround R Surround L
0 dB "__" "__"
LINE-2 REC OUT
TAPE ON
Subtitle Disc Menu
OFF English
Wall Paper
Blue
TV Type Video Mode Black level
NTSC AUTO
LPCM Select
OFF
Pass Word Change
0000 (Default)
Slide Show
5SEC
ENGLISH
Yes
Surround
"__"
Sub Woofer
0 dB
LIGHTER
29