Special Mode Setting Button - Denon AVR-3311CI Service Manual

SPECIAL MODE

Special mode setting button

b Press the ON/STANDBY button to turn on while pressing both buttons A and B at the same time.
Mode
Version display
(μcom/DSP Error Display)
Displaying the protection history mode
IInitialization mode
(Remove settings for Installer Setup.)
Initialization mode
(Includes settings for Installer Setup)
Mode for switching tuner frequency step
Mode for preventing remote control
acceptance
Panel lock mode
Panel lock mode
(Remove Master volume)
Cancellation of panel lock mode
Installer Setup mode
Diagnostic mode
NOTE:
If " S " is displayed on the fluorescent display, the unit is set to the special developer's mode and RS-232C
communications are not possible.
Press and hold in the "STATUS" and " i " buttons for over 3 seconds with the power turned on to turn the " S "
display off. RS-232C communications are now enabled.
STANDARD
Button A Button B
STATUS RETURN
STATUS
STANDARD
SIMULATION
CURSOR
CURSOR UP
DIRECT/
STANDARD
STEREO
STATUS
DSP DIRECT/
SIMULATION STEREO
DIRECT/
STEREO
DIRECT/
STEREO
CURSOR
MENU
CURSOR
LEFT
PURE
DIRECT/
DIRECT
STEREO
DSP
SIMULATION
ZONE2 MENU
ON/OFF
Serial No. and firmware versions such as Main, Sub, DSP are
displayed in the FL manager. Errors are displayed when they
occur. (Refer to 16 page)
Displaying the protection history
MENU
(Refer to 19 page)
DSP Backup data initialization is carried out.
(Remove settings for Installer Setup)
Backup data initialization is carried out.
DOWN (Includes settings for Installer Setup)
---E2 model only---
Change tuner frequency step to FM:200kHz/AM:10kHzSTEP
Operations using remote control are rejected.
ENTER (Mode cancellation: Turn off power and execute the same
button operations as when performing setup.)
Operations using main unit panel buttons or master volume are
rejected.
PURE
Operations using main unit panel buttons are rejected.
DIRECT
ENTER Panel lock mode is cancelled.
Access Remote Maintenance mode via the internet.Installer
Setup is displayed on GUI/Option Menu.
LEFT
※ Refer to AVR_RemoteMaintenance_.pdf of SDI.
This mode is used for confirming the Video and Audio (signal)
ENTER paths. (Troubleshooting)
Confirming the operation of unit can be easily done after repair.
ENTER
STATUS
CURSOR RETURN
15
Contents
d