Table of Contents
Advertisement
Chapter 8. Dedicated Maps Terminal Menu
8-4
n
N
Data Rate
Write security:3; Read security:5
Defines the data rate per DS0. If FROM Slt is an Nx port,
the data rate per DS0 must be set. You can choose from
64 kbps or 56 kbps.
Trunk
Security level: 3; Read security: 5
Conditioning
Sets known values in the signaling bits and the data field
for outgoing DS0s which are cross-connected to a T1 port
experiencing alarms.
The trunk conditioning process consists of a 2.5-second
transmission (indicating call termination), followed by a
continuous transmission signaling the final condition as
chosen by the user.
Fault
Signaling
Fault State
Custom
See also the trunk conditioning example on page 8-5.
PLUS
ATLAS 800
This DS0 is already used in this Dedicated
Map.
This DS0 is already used in this Dedicated
Map and conflicts with this connection.
Trunk conditioning only applies to RBS T1s in the
dedicated map.
Defines to ATLAS the type of signaling being
used on the trunk:
E&M
LS/GS Network or User
SW56
Custom
Fault signaling is only visible when RBS is turned
on.
Defines the final fault signaling state:
Idle - used for one-way trunks; that is, for out-
going or incoming calls only—not both.
Seized - used for two-way trunks. Prevents
the PBX from attempting to use a failed trunk
for an outgoing call.
Permits users to define the Fault Signaling to
use in the form of A/B set to 1/0.
User Manual
61200226L1-1
Advertisement
Table of Contents
