Table of Contents
Advertisement
»» Called Digits
Transferred
»» Outgoing Caller ID
» ID Presentation
» ID Number
» Source ID
»» Swap ANI/DNIS
61200226L1-1
versus data calls. A setting of
been subscribed.
Write security: 3; Read security: 5
Defines to ATLAS the number of called-number digits to forward. When
attached to a PBX, the PBX may be provisioned to expect to receive fewer
than all of the called digits of the incoming call. This would normally be set
to
.
All
Write Security: 3 Read Security: 5
This item allows the user to insert a called ID to be added to outgoing calls
(coming in from attached User equipment). If set to
ATLAS will forward whatever ID it receives (including none). If set to
, then ATLAS will insert a User defined ID value if no
stitute if not present
value is received. If set to
the User defined ID in place of the value received.
Defines control information for the presentation of Caller ID to be inserted
(
Presentation Allowed; Presentation Restricted; Number Not Available
Value for Caller ID to be sent to the Network (i.e., 256 963 8020).
The Source ID field simplifies the creation of a Dial Plan in applications
where the criterion for switching calls to a certain end point is a function of
which end point originated the call.
•
Default value = 0. The default ID for all end points is 0 and all accept # s
is 0. With default values, all calls are routed based only on dialed num-
ber.
•
Multiple end points can have the same Source ID .
•
When creating the Call Accept list, specify a Source ID (s) as well as a di-
aled number or range of dialed numbers to accept.
For example, an application requires that all calls originating from Port 1 of
the Quad T1/PRI module in Slot 1 be switched to Port 4 of that same mod-
ule. Assign a unique Source ID (e.g., 7) to Port 1 of the module, and then
configure Port 4 to only accept calls from that unique Source ID (7).
This option swaps the ANI and DNIS numbers prior to being forwarded to
the attached user equipment. ANI (Automatic Number Identification) is
the billing number of the calling party, and DNIS (Dialed Number Identifi-
cation Service) is the called party number.
This swap will occur after the ATLAS switchboard has routed the
call. The accept # in the dial plan must use the number in the DNIS
position prior to swapping.
PLUS
ATLAS 800
Chapter 10. Dial Plan Terminal Menu
indicates no special facilities have
Normal
, then ATLAS will always insert
Substitute Always
User Manual
, then
Send as Provided
Sub-
).
10-15
Advertisement
Table of Contents
