Table of Contents
Advertisement
61200226L1-1
Setting User Term Connections
Step
1
Navigate to User Term.
Enter connections for BRI D,E, and F in the same manner as BRI
2
A, B, and C: use the copy ( C ) and paste ( P ) commands to enter
the appropriate Out#Accept and Out#Reject numbers.
Ensure that the SPID and Phone entries under Ifce Config match
3
the SPID and phone numbers of the attached equipment.
Enter the connection for T1-A: select RBS under Sig, and enter
4
1-900-$ under Out#Reject .
5
Set Trunk Type (under Ifce Config ) to Analog .
6
Set Signaling Method to E&M Wink .
7
Set DID (under Ifce Config ) to enabled.
8
Set the DID Digits Transferred to 4 .
When you complete the User Term Dial Plan, it appears as shown in Figure
10-7.
PLUS
ATLAS 800
Chapter 10. Dial Plan Terminal Menu
Figure 10-6. Completed Network Map
Action
User Manual
10-27
Advertisement
Table of Contents
