Changing The Patient Id - Mcube CUBEscan BioCon-500 User Manual

5.4

Changing the Patient ID

1) Press DOWN (P_ID menu) on the Top Screen.
Then a user can see the Patient ID Input Screen as follows.
Context Menus
LCURS-←
2) Change the Patient ID.
To move the cursor, press LEFT (LCURS option) or RIGHT (RCURS option).
To change the value at the selection point, press UP (NUP option) or DOWN
(NDOWN option)
IMPORTANT:
3) Go to Top screen by pressing PRINT (EXIT option) after editing the
patient ID.
Patient ID
0 1 2 3 4 5 6 7 8 9
NUP-↑ NDOWN-↓
Fig 13 Patient ID Input Screen
The patient ID consists of 10 digits.
The patient ID is not saved in flash ROM, so after restarting
the system the patient ID will be reset to '0000000000'.
49
`
RCURS-→
Cursor
EXIT-P