Setting The Date & Time - Mcube CUBEscan BioCon-500 User Manual

5.7 Setting the Date & Time
1) Press UP
2) With the selection cursor to the left of 'Set Data/Time', press ENTER (SELCT
option).
The selection cursor in the Setup Screen will be moved to the right as shown
below.
Context Menus
LCURS-←
3) Changing the date and time is done through using the contextual options.
To move the cursor, use LEFT (LCURS option) or RIGHT (RCURS option).
To change the numeric data above the cursor use UP (NUP option), and
DOWN (NDOWN option).
4) When done editing the date and time, save the changes using ENTER
(ENTER option). The position curser will return to the left of the screen.
(SETUP option) on the Top Screen.
Position Cursor
In Setup Screen
Clinic Name
Set Date/Time
Print Option
Flash Store
Setup Print
Scan Result
Auto Power
Calibration
Prescan Enable
Exit
NUP-↑ NDOWN-↓
Fig 18 Setup Date/Time Screen
MCUBETECH
2007/10/10 15:00
Raw Image
On
B-Mode
7 minutes
Return
On
RCURS-→ ENTER-E
54
Cursor