Operation Instructions; Description Of Lcd And Buttons - Goodwe HT Series User Manual

5 Operation Instructions

5.1 Description of LCD and Buttons

SolarGo App
Safety Country Setting:
If the LCD displays "GW250K-HT Power = XXXXX watts" or "GW225K-HT Power = XXXXX watts" ,
press and hold for 2s to enter the submenu "max voltage in China" . Select safety country in the
submenu according to your location and wait for 10s after selecting the country. The LCD will display
"Setting up..." . Then you will get a feedback like " Setup successfully" or "Setup failed" .
(1) The LCD shows as following:
Grid-tied power generation
Power = XXXXX watts
(2) Description of the display:
1st row
2nd row
1st row: status information:
*The first row shows the status information of the system.
"Waiting for power generation
"Detection timing **sec
preparing to generate;
"grid-tied power generation
generation state;
When the system is abnormal, an error message will be displayed. For details, refer to the *5.2 Failure
Information* table.
*The operating parameters of the system can be switched and displayed in the status bar by pressing
the buttons. Press the buttons to switch the menu and submenu. The detailed contents and
procedures can be seen below.
*The menu display is controlled by the buttons. Long press the button to enter the submenu.
2nd row: This area displays the real-time power generation of the inverter.
(3) Button Description:
The two operations to control the buttons: short press and long press
(4) Details of buttons and LCD screen:
*The basic functions can be set by pressing the buttons, such as time, language, safety country, etc.
And the data can also be checked by pressing the buttons.
*Menu and submenu status can be displayed on the LCD screen. Long press the button to entry
submenu from menu. If there is no submenu, press and hold for 2 seconds to lock the current display
interface.
*For both menu and submenu, the system will automatically revert to the first item of menu after 20
seconds if no button is pressed.
(5) Menu Introduction:
*After the inverter is powered on, the menu is the initial interface.
*The status display is the first item of the menu, which displays the current status of the inverter.
When the inverter start to be powered on, the LCD displays "Waiting for power generation". If it is
generating, it displays "Grid-tied power generation". If the inverter is faulty, the fault information is
displayed.
*Short press the button once to enter the input voltage display menu, which is used to display the PV
voltage in "V".
Note:
For inverters without LCD, please scan the QR code left to download and install
the SolarGo App, and complete the corresponding configuration operations in
the App.
power = 0 watts" indicates the inverter is in standby state;
power = 0 watts" indicates that the inverter is self-checking and
power =XXXXX watts" indicates that the inverter is in power
23