LifeFitness CLUB Series Assembly Instructions Manual page 14

FIGURE 13
41
12 3/8 X 2-1/2"
22
8
28
27
TIGHTEN!
1A
38
33
STEP 13:
• SECURELY assemble the GUIDE ROD SUPPORT (8) to the TOWER (1) using four RH CAPS (41), two 3/8 X 2-1/2" BOLTS
(12), four 3/8" RH WASHERS (22) and two 3/8" LOW HEIGHT LOCK NUTS (19) as shown in FIGURE 13.
• Slide GUIDE ROD BUSHINGS (28) into the tubes on the GUIDE ROD SUPPORT (8), slide 1" SHAFT COLLARS (27) under-
neath the GUIDE ROD BUSHINGS (28) and SECURELY tighten the set screws.
• Screw the threaded end of the CABLE all the way into the end of the shaft on the HEAD PLATE (38) and tighten jam nut
securely. See FIGURE 13.
• Insert the WEIGHT STACK PIN (24) into the WEIGHT STACK as shown in FIGURE 13.
1/2
0
19
1/2 1/2
1 2
1
24
1/2 1/2
3 4
14
1/2
5 6