Related Manuals for WATSON Essential Desk Stand By Power & Mobility Kit
Summary of Contents for WATSON Essential Desk Stand By Power & Mobility Kit
- Page 1 ASSEMBLY Essential Desk Stand By Power & Mobility Kit 360.394.1300 watsonfurniture.com V.21.0 12/2021...
- Page 2 Essential Desk Stand By Power Kit Components Linak Power Cable 200mm Cable Linak External Charging Components Linak BA001 LI Battery Linak External Charger Essential Desk Mobility Kit Components Casters Caster Stems Locking Casters 2 ESSENTIAL DESK STAND BY POWER & MOBILITY KIT ASSEMBLY INSTRUCTIONS...
- Page 3 Hardware #8 x 5/8” Flat Head Screw (116754) Tools Electric Drill Phillips Bit 1/2” Wrench 3 ESSENTIAL DESK STAND BY POWER & MOBILITY KIT ASSEMBLY INSTRUCTIONS...
- Page 4 Mobility Kit: Install Casters Remove the glides and replace them with the (4) stems using a 1/2” wrench to tighten the stems snugly. Push the casters onto the stems. Place the locking casters at the front of the desk for easier access. A helpful tip when installing the casters is to prop the desk onto a taller object, to allow for access to the desk feet.
- Page 5 Stand By Power Kit: Install Battery Pack Remove the battery bracket from the back of the battery by sliding the bracket off of the battery (a.). Using (4) screws secure the bracket to the underside of the desk surface (b.). Once the bracket is secured, install the battery by sliding the battery onto the bracket until it clicks (c.).
- Page 6 Stand By Power Kit: Connect Battery to Control Box Connect the 200mm cable to the battery and route it to the control box located in the Support Rail, on the underside of the work surface. Plug into the 2 port connection labeled DC. For more information on use of external charger & power cord, refer to Linak Battery Pack manual, QR code/link below.