Advertisement
Quick Links
Advertisement
Related Manuals for WATSON Haven
Summary of Contents for WATSON Haven
- Page 1 ASSEMBLY Haven Table & Media Screens 360.394.1300 watsonfurniture.com V.21.0 12/2021...
-
Page 2: Screen Components
Screen Components Screen Monitor Brackets Table Bracket Monitor Mount Lock Bar 2 HAVEN TABLE AND MEDIA SCREENS ASSEMBLY INSTRUCTIONS... - Page 3 BHSCS M6-1.0 #10 X 1” Tor x Head 8-32 ZInc Plated Nut x 16mm Black Screw (0002147) (117011) (125278) Wire Management Clip(486911) Tools Electric Drill 4mm Hex Bit T25 Tor x Socket 11/32” 3 HAVEN TABLE AND MEDIA SCREENS ASSEMBLY INSTRUCTIONS...
- Page 4 Align the Table Bracket with the pilot holes in the worksurface and drive (7) screws to secure it in place. Be sure to leave the square hole empty. #10 X 1” Tor x Head Screw (0002147) 4 HAVEN TABLE AND MEDIA SCREENS ASSEMBLY INSTRUCTIONS...
- Page 5 Drive Screws Into Screen Drive (2) screws into the second lowest set of holes on the Screen until there is 1/8” gap between the screw head and the Screen. BHSCS M6-1.0 x 16mm Black (125278) 5 HAVEN TABLE AND MEDIA SCREENS ASSEMBLY INSTRUCTIONS...
- Page 6 Attach Screen to Bracket Drive (4) additional screws and tighten the two existing screws to secure the Screen in place. BHSCS M6-1.0 x 16mm Black (125278) 6 HAVEN TABLE AND MEDIA SCREENS ASSEMBLY INSTRUCTIONS...
- Page 7 Slide the Screen onto the Table Bracket by aligning the (2) screw heads with the keyslots in the bracket. Lower the Screen until it is fully seated in the keyslots. BHSCS M6-1.0 x 16mm Black (125278) 7 HAVEN TABLE AND MEDIA SCREENS ASSEMBLY INSTRUCTIONS...
- Page 8 Align the wire management clip with the square hole in the Table Bracket. Then drive the screw through the wire management clip until secure #10 X 1” Tor x Head Wire Management Screw (0002147) Clip(486911) 8 HAVEN TABLE AND MEDIA SCREENS ASSEMBLY INSTRUCTIONS...
- Page 9 Situate the power unit in the associated power bracket. Slide the assembly on the included studs on the side of the Table Bracket. Thread a nut on each stud to secure the unit in place. 8-32 ZInc Plated Nut (117011) 9 HAVEN TABLE AND MEDIA SCREENS ASSEMBLY INSTRUCTIONS...
- Page 10 Monitor mount hardware. The addtional holes in the brackets can be used to adjust the height of the Monitor. Plug in the power cable and any additional data cables to the Monitor. BHSCS M6-1.0 x 16mm Black (125278) 10 HAVEN TABLE AND MEDIA SCREENS ASSEMBLY INSTRUCTIONS...
- Page 11 (Optional) Mount Monitor to screen Hang the Monitor/bracket assembly on the Monitor mount and route cables down through the elastic cording. HAVEN TABLE AND MEDIA SCREENS ASSEMBLY INSTRUCTIONS...
- Page 12 (Optional) Lock TV to screen Slide the Lock Bar through the Monitor Mount and through both Monitor brackets. Place a lock through the hole in the end of the lock bar. (Monitor not shown for visibility) HAVEN TABLE AND MEDIA SCREENS ASSEMBLY INSTRUCTIONS...