User Manual
2.29.2 Join a 'Meet me' conference
Once set-up by the conference initiator, other participants can join the 'Meet me' conference.
•
Enter the joining code for the 'Meet me' conference. This code is defined by the administrator
during system configuration. If necessary you may need to contact your administrator.
•
Enter the conference access code.
Conference access code: 'x' digits code defined by the conference master and communicated to
the participants so that they can join the conference.
•
You are in conference mode.
An audible beep rings when a participant joins the conference.
You cannot join a conference if there are already the maximum number of participants.
If you cannot directly reach the conference, you have to call first an internal user or an Attendant Set.
This one dials the call number for joining the 'Meet-me ' conference and then transfers your call (10
seconds).
2.30 Intrusion into an internal conversation (barge-in)
Your contact's line is busy. If the number is not 'protected' and if authorised, you can intrude into the
call:
•
Intrusion
•
Same key to exit (Intrusion).
2.30.1 Protect a call against intrusion
•
Press programmed key. The programmed key has to be configured by the system:
intrud) (by default).
•
Enter contact's number.
Protection is cancelled when you hang up.
2.31 Signal malicious calls
This key lets you signal a malicious call. If this call has an internal source, it is signalled to the system by
a special message.
•
You receive a malicious call.
•
Malicious
2.32 Recording the current conversation
The visibility of this feature depends on the system configuration managed by your administrator.
When you are on a call with one or more callers, you can record the conversation. At the start or end of
recording, your caller hears a beep.
The user must have the appropriate rights to use this feature. Recorded conversations will then appear
as voicemails.
To record the conversation during communication:
•
Record
Start recording.
•
Recording in progress
Restart rcrd
o
Stop rcrd
o
Pause
/
o
8AL90399ENAAed01
To restart recording.
To stop the recording.
Resume rcrd
Pause/resume the recording.
No intrusion (No
44 /101