Table of Contents
Advertisement
Starting the diesel engine
To start the diesel engine when the
engine is cold, it has to be pre-heated
and then it has to be warmed up, before
starting to drive.
Vehicle with Intelligent Manual
Transmission :
1. Make sure the parking brake is
applied.
2. Depress the clutch pedal fully and
shift the transmission into Neutral.
3. Keep the clutch pedal and brake pedal
depressed while pressing the ENGINE
START/STOP button to the START
position.
If you press the ENGINE START/STOP
button to the START position without
depressing the brake pedal and clutch
pedal, the engine will not start.
Vehicle with dual clutch transmission:
1. Always carry the smart key with you.
2. Make sure the parking brake is
applied.
3. Make sure the shift lever is in P (Park).
4. Depress the brake pedal.
5. Press the Engine Start/Stop button.
6. Continue depressing the brake pedal
until the glow indicator light (
goes out.
7. When the glow indicator light (
goes out, the engine will start.
Information
If the Engine Start/Stop button is pressed
while the engine is pre-heating, the engine
may start.
Starting and stopping the engine for
turbocharger intercooler
1. Do not race or accelerate the engine
immediately after starting the engine.
If the engine is cold, idle for several
seconds before sufficient lubrication
is ensured in the turbocharger.
2. After high speed or extended driving
that requires heavy engine load, idle
the engine about 1 minute before
turning the engine off. This idle time
will allow the turbocharger to cool
prior to shutting the engine off.
NOTICE
Do not turn off the engine immediately
after it has been subjected to a heavy
load. Doing so may cause severe
damage to the engine or turbocharger.
)
)
06
6-13
Advertisement
Chapters
Table of Contents
