Hyundai KONA 2021 Owner's Manual page 200

Convenient features
Headlamp delay function
(if equipped)
If you place the ignition switch to the
ACC or OFF position with the headlamps
ON, the headlamps (and/or position
lamps) remain on for about 5 minutes.
However, with the engine off if the
driver's door is opened and closed, the
headlamps (and/or position lamps) are
turned off after 15 seconds.
The headlamps (and/or position lamps)
can be turned off by pressing the lock
button on the remote key or smart key
twice or turning the light switch to the
OFF or AUTO position. However, if you
turn the light switch to the AUTO position
when it is dark outside, the headlamps
will not be turned off.
You can activate or deactivate the
Headlamp Delay function from the User
Settings mode on the LCD display. For
more details, refer to "LCD Display" in
chapter 4.
NOTICE
If the driver gets out of the vehicle
through other doors (except driver's
door), the battery saver function
does not operate and the headlamp
delay function does not turn off
automatically. Therefore, It causes the
battery to be discharged. In this case,
make sure to turn off the headlamps
before getting out of the vehicle.
5-50
Daytime running light (DRL)
(if equipped)
The Daytime Running Lights (DRL) can
make it easier for others to see the front
of your vehicle during the day, especially
after dawn and before sunset.
The DRL system will turn the dedicated
lamps OFF when:
1. The headlamps or front fog lights are
in the ON position.
2. The position light switch is in the ON
position.
3. The engine is turned off.
Headlamp leveling device
(if equipped)
Manual type
To adjust the headlamp beam level
according to the number of the
passengers and loading weight in the
luggage area, turn the beam leveling
switch.
The higher the number on the switch
position, the lower the headlamp beam
level. Always keep the headlamp beam
at the proper leveling position, otherwise
headlamps may dazzle other road users.
Listed below are examples of appropriate
switch settings for varying loads. For
loading conditions other than those
listed, adjust the switch position to the
most similar situation.
OOS040049 OOS040049