Table of Contents
Advertisement
3.4 Removing the ICP-D
Required tools
•
Flat screwdriver 7 mm
•
Phillips screwdriver PH2
•
ESD wrist band
How to remove the ICP-D from the projector Card Cage
1.
Depending on the projector type the input cover of the projector has to be removed to access the fixation
screws of the installed ICP-D. Flat screwdriver may be needed for this action. For detailed instructions see
User & Installation manual of the projector.
2.
Release the two retaining screws at the front of the ICP-D (reference 1). Use a PH2 Phillips screwdriver.
Caution:
Ensure that the slot located under the ICP-D is empty during this procedure. For
mechanical reasons the ICP-D board cannot be manipulated (removal/installation) when the 3rd
party IMB board is still inserted.
3.
Pull the ICP-D out of its compartment.
Note: All connections are made via the board to board connection with the back plane.
ICP-D removal from card cage of projector:
1
Image 3–2
Removal of the ICP-D from the Card Cage of the projector will result in tamper events (service door
tamper, insertion tamper).
ICP-D installation
R5912083 /01
ICP-D
23
Advertisement
Table of Contents
