Installation In The Icon H250/H400/H500 And In The Id H250/H500; Removing The Pmp - Barco iCon H250 Installation Manual

4. INSTALLATION IN THE ICON H250/H400/H500 AND
IN THE ID H250/H500
The software version of the projectors must be 1.30 or higher. Lower versions do not support this DVI HDCP
input board!
The iCon H400 is replaced by the iCon H500 and will not be mentioned in the procedure. The procedure below
is valid for both models.
In this projector models, the DVI HDCP input board must be put in the place of the 'old' DVI input board!
Overview
•

Removing the PMP

• Removing the input module
• Replacing the DVI / D15 input
• Installing the DVI HDCP input layer
4.1 Removing the PMP
To install this input upgrade kit, it is not necessary to completely remove the PMP. The input module can be
made accessible by disconnecting the PMP partially and just flipping it over.
Necessary tools
• Torx screwdriver T10
• Nut spanner 5 mm
How to flip over the PMP?
1. Remove the front screw, fixing the upper part of the front panel to the input module
Image 4-1
iCon and iD H250/H500: fixing screw of the front plate upper part
2. Remove the 6 bolts, fixing the upper part of the front panel to the PMP
R59770246 DVI HDCP INPUT KIT 28/04/2008

4. Installation in the iCon H250/H400/H500 and in the iD H250/H500

13