Table of Contents
Advertisement
General
Battery tamper check
Prior to installation inspect the tamper labels (reference 2 Image 1–2) of the battery slots on the ICP-D board.
Damage labels could indicate an intrusion of the battery sockets.
If there is no battery present or the battery was temporally removed the certificates stored on the ICP-D are
deleted. As a result the ICP-D goes into a non recoverable error state and makes the ICP-D out of order. If this
is the case, the ICP-D must be sent back to factory to install new certificates. Contact Barco technical support.
Image 1–2
2
Tamper label
T
TOP
B
BOTTOM
CAUTION: Always leave a working battery on the ICP-D. Removing all the batteries at the same
time will cause immediate failure of the ICP-D. The only way to recover the functionality of the ICP-
D is return it to the manufacturer in order to reset the ICP-D and install new certificates.
The lifetime of the battery is approximately 5 years. When the battery voltage is low the ICP-D will
throw a warning message to replace the battery immediately.
CAUTION: Only certified service technicians are allowed to replace the battery of the ICP-D.
12
R5912083 /01
ICP-D
Advertisement
Table of Contents
