Table of Contents
Advertisement
INSTALLATION
AQUA GRAZE MOUNTING AND ADJUSTING
When installing Aqua Graze fixtures, ensure that the surface is level and that nothing is
protruding to damage the mounting brackets. Suitable mounting surfaces include steel,
aluminum, concrete or wood structures.
Each mount bracket has two slots measuring
0.39" x 0.18" (10 x 4.5mm) and the base has a
thickness of 1/8" (3mm). Select bolts or screws
(not supplied) that fit the mount bracket base(s)
correctly and are particularly suited to the
mounting surface.
The Aqua Graze can be tilted roughly 53
each direction from vertical. Use a 1/8" (3mm)
Allen wrench to loosen the tilt bolts on the
mounting brackets at each end of the fixture.
If a mount bracket needs to be moved along the length of the fixture, you will need to
temporarily remove the mount bracket base in order to gain access to the slide screw.
TO ADJUST THE MOUNT BRACKET
1 Use a 1/8" (3mm) Allen wrench to loosen the
tilt bolt until the mount bracket base can be
removed from the pillar:
Mount
bracket
pillar
Slide screw 1/16" / 1.5mm
Allen wrench required
2 Use a 1/16" (1.5mm) Allen wrench to loosen the slide screw and move the pillar to the
required position.
3 Re-tighten the slide screw.
4 Refit the base onto the pillar and tighten the tilt bolt.
in
O
www.acclaimlighting.com
O
53
Mount
bracket
base
Tilt bolt 1/8" / 3mm
Allen wrench required
O
53
3
Advertisement
Table of Contents
