Table of Contents
Advertisement
STANDALONE MODE USING INTERNAL CHASE PROGRAMS
In standalone mode, all four ports are treated as one group. Note: all switch settings can be
changed when the driver is off or on. To configure the Aqua Driver for standalone chase mode
you need to:
1 On the 10-way switch block, set switch 10 OFF to
choose standalone mode.
2 Use switches 1 to 3 of the 10-way switch block to
choose the required fade time between chase steps.
If all three switches are OFF, the chase states will snap
between each other. All three switches ON will produce
the smoothest fade (Note: switch 3 is weighted as the
most significant bit).
3 Use switches 4 to 6 of the 10-way switch block to
choose the required speed of chase. If all three switches
are OFF, the chase will run at its fastest speed, with 0.1
seconds between steps.
4
5
OFF
OFF
OFF
ON
OFF
OFF
OFF
ON
OFF
ON
ON
OFF
OFF
OFF
ON
ON
OFF
ON
OFF
ON
ON
ON
ON
ON
4 Use switches 7 to 9 of the 10-way switch block to
choose the required program. If all three switches
are ON, an Auto mode will cycle between all of
the available programs.
6
Speed
0.1 seconds
0.2 seconds
0.5 seconds
1 second
5 seconds
10 seconds
20 seconds
30 seconds
www.acclaimlighting.com
Standalone mode: OFF
6
7
8
Fade time
1
Speed
3
4
Program
6
7
8
ON
9
10
2
3
4
5
6
7
ON
9
10
15
Advertisement
Table of Contents
