Panasonic KX-TD816AL User Manual page 35

2.1
To confirm the assigned function data
— Be sure that you are in the Station Programming mode : Press [PROGRAM] [9] [9].
1
access number
2
HOLD
— To exit from Station Programming mode : Press [PROGRAM] or lift the handset.
— If you wish to change the data, follow the programming procedure explained in this
section.
*
Programming access number is required to program/confirm the function data by Station Programming.
To confirm the assigned data on the Flexible button
— Be sure that you are in the Station Programming mode : Press [PROGRAM] [9] [9].
1
2
HOLD
— To exit from Station Programming mode : Press [PROGRAM] or lift the handset.
— If you wish to change the data, follow the programming procedure explained in this
section.
Programming Instructions
1. Enter the programming access number
• Each number corresponds to the data as follows:
- 0 : Remote Station Lock Control (— Operator only)
- 1 : Preferred Line Assignment — Outgoing
- 2 : Preferred Line Assignment — Incoming
- 3 : Full One-Touch Dialing Assignment
- 4 : Intercom Alerting Assignment
- 5 : Call Waiting Tone Type Assignment
- 6 : Self-Extension Number Confirmation
- 7 : CO Incoming Call Information Log Lock Clear
(— Operator only)
- 8 : Charge Fee Reference
- 9 : Handset /Headset Selection
- # : Station Programming Data Default Set
The display shows the programmed data.
•
<Example> When you press [5], the display shows:
C.W. Tone 1
(— Call Waiting tone is now programmed to Tone 1)
2. Press the HOLD (END) button.
• The display shows the initial programming mode.
1. Press the desired Flexible (CO, DSS, PF) button.
• The display shows the current status.
2. Press the HOLD (END) button.
• The display shows the initial programming mode.
(0 through 9 and #).
*
Station Programming
2-3