Table of Contents
Advertisement
3.3.2.1 NGT-1000/-2000/-2500 Version 1
1.
Verify that the following messages are not shown on the display. If a message is observed, cycle
power to the Lynx MSS system. If the message continues to be shown, refer to the appropriate Lynx
MSS Installation Manual for detailed troubleshooting information or contact ACSS Field Service.
•
NO LRU RESPONSE (incorporated in CP-2500 Firmware 15 and later)
•
GPS FAIL
•
ADS-B SYSTEM FAIL
2.
The following messages may be seen, but do not indicate a problem with the CP-2500 or the Lynx
MSS.
•
GPS INIT: This message is removed after the GPS completes initialization.
•
NO ADS-B COVERAGE: (NGT-2000/-2500 only) This message is removed once the Lynx MSS
begins receiving an ADS-B ground station signal.
•
MODE A CODE PUSH TO ACCEPT XXXX: The Lynx MSS is receiving a code from the
transponder, but the code shown on the CP-2500 does not match. The XXXX is a representation
of the code being received from the transponder. Press the small knob button to change the CP-
2500 code to the same code as the transponder.
3.3.2.2 NGT-1000/-2000/-2500 Version 2
1.
Verify that the following messages are not shown on the display. If a message is observed, cycle
power to the Lynx MSS system. If the message continues to be shown, refer to the appropriate Lynx
MSS Installation Manual for detailed troubleshooting information or contact ACSS Field Service.
•
GPS FAIL
•
ADS-B OUT FAIL
•
ADS-B IN FAIL
•
NO LRU RESPONSE (incorporated in CP-2500 Firmware 15 and later)
•
FIS-B FAIL (NGT-2000/-2500 only)
2.
The following messages may be seen, but do not indicate a problem with the CP-2500 or the Lynx
MSS.
•
GPS INIT: This message is removed after the GPS completes initialization.
•
NO ADS-B COVERAGE: (NGT-2000/-2500 only) This message is removed once the Lynx MSS
begins receiving an ADS-B ground station signal.
•
MODE A CODE PUSH TO ACCEPT XXXX: The Lynx MSS is receiving a code from the
transponder, but the code shown on the CP-2500 does not match. The XXXX is a representation
of the code being received from the transponder. Press the small knob button to change the CP-
2500 code to the same code as the transponder.
•
CODE MISMATCH CHECK TRANSPONDER: The Lynx MSS is not receiving a Mode A code
from the transponder. Verify transponder is set to "ALT" mode.
0040-17251-01
Revision D
CP-2500
Installation Manual
Installation Checkout
Page 3-3
March 15, 2018
Advertisement
Table of Contents
