Installation; Performance Test; Remove And Replacement Procedures - L3 CP-2500 Installation Manual

2.3.3 Installation

Once a mounting location is determined using the recommendations outlined in paragraph 2.3.1, perform
the following to the extent necessary to install the CP-2500:
1. Cut the proper sized hole per dimensional instructions provided in Figure 2-1.
Installer must take into consideration the length of the wiring harness
before installing the CP-2500 into the instrument panel. The connection
of mating connector may be required before installation of the unit.
2. The CP-2500 mounts on the backside of the instrument panel. Carefully hold the CP-2500 in place
behind the instrument panel.
3. Secure CP-2500 to instrument panel using (4) mounting screws (provided in the installation kit) and
mooring plate or nut plates (as applicable).

2.3.4 Performance Test

After installation is completed, complete the installation checkout procedures detailed in section 3.

2.3.5 Remove and Replacement Procedures

If the CP-2500 requires removal after initial installation, replace it using the instructions given in the
maintenance section of this manual and perform the Installation Checkout procedures located in the
Installation Checkout Section of this manual.
0040-17251-01
Revision D
CP-2500
Installation Manual
NOTE
Installation Page 2-9
March 15, 2018