Jumper Plug Setting - Toshiba PROSEC T3 User Manual

5.2 Jumper plug setting

2 jumper plugs are provided on the PI312's printed circuit board. Use tweezers to
change the settings.
J2 is used to select either individual operation (other than slave counter/timer mode) or
relative operation (slave counter/timer mode).
J2 Short
(factory setting)
Open
J1 is used to select the PI312's initialization mode.
J1 A side
(factory setting)
B side
By the initialization, the operation mode is reset to the up/down pulse counter mode,
and the contents of the PI312's buffer memory is cleared to 0.
PI312 rear view
Individual operation
(for modes (1) through (7) on the previous page)
Relative operation
(for modes (8) and (9) on the previous page)
PI312 is initialized at both power on and the beginning of
T3 RUN.
PI312 is initialized only at power on.
5. Operation Mode Setting
Jumper plugs
(J1 and J2)
J2
!
• Remove the PI312 from the rack before
setting
the jumper plugs on the PI312.
Do not touch other components on the
PI312's
J1
B
CAUTION
User's Manual
47