Toshiba PROSEC T3 User Manual page 33

Hide thumbs Also See for PROSEC T3:

Table of Contents

• Hardware comparison output signals

2 points of hardware comparison output are provided for each channel. 1S1 and 1S2

are for channel 1, and 2S1 and 2S2 are for channel 2.

The output method is 24 Vdc transistor output (current sinking).

The figure below shows the typical wiring connections.

PI312

1S1

1S2

2S1

2S2

24Vdc (+)

24Vdc (-)

NOTE

(1) The hardware comparison output function is enabled when the output-enable flag

is set to ON. Refer to section 4.1 for the output-enable flag.

(2) The 24 Vdc power is not required if the hardware comparison outputs are not

24 Vdc

used.

3. Wiring

Load

User's Manual

Table of Contents