Toshiba PROSEC T3 User Manual page 62

6. Function Details
6.3 Auto-reset universal counter mode
(1) Mode setting
Jumper plug (J2) = Short
Operation mode data = H0081 (129) ... Normal count mode
This mode can be set individually for channel 1 and channel 2.
(2) External signals
Signal
Phase A
Phase B
Phase G
Phase M
EXT
S1
S2
(3) Buffer memory
Name
Count value
Set-point-1
Set-point-2
Hold value
Interrupt flag
Mode register
(4) Command register (YW)
Name
Soft-gate
Interrupt-enable
Output-enable
60
Pulse Input Module (PI312)
= H00C1 (193) ... Precision count mode
Counting up pulse
No use
Used to enable the counter operation
(enabled while both phase G and soft-gate are ON)
No use
No use
No use
No use
Address
(CH1/CH2)
Stores the count value (read/write)
1⋅0 / 9⋅8
Used to set the reset point (read/write)
3⋅2 / 11⋅10
No use
5⋅4 / 13⋅12
Stores the count value at the gate comes OFF (read)
7⋅6 / 15⋅14
16 Used for interrupt function (read)
32 / 33 Used to set the operation mode (read/write)
Bit position
(CH1/CH2)
0 / 4 Used to enable the counter operation
(enabled while both phase G and soft-gate are ON)
1 / 5 Set to ON to enable interrupt function
2 / 6 No use
Function
Function
Function