Installation - ADJ 15 HEX BAR IP User Manual

INSTALLATION

Always ensure that the unit is firmly fixed to avoid vibration and slipping while operating. Always
ensure that the structure to which you are attaching the unit is secure and is able to support at least
10 times the unit's weight. ALWAYS use safety cables that can hold at least 12 times the unit's
weight when installing the fixture.
This equipment must be installed by a professional, and it must be installed in a place where it is out
of the reach of people's grasp. Overhead mounting requires extensive experience, including calculat-
ing working load limits, knowledge of installation material being used, and perodic safety inspection
of all installation material and the unit itself. If you lack these qualifications, do not attempt the instal-
lation yourself. The installation should be checked by a skilled person once a year.
Ensure ALL connections and end caps are properly sealed with a non-conductive dielectric
grease (available at most electrical suppliers) to prevent water ingress/condensation and/or
corrosion.
The 15 Hex Bar IP is fully operational in three different mounting positions: hanging upside-down,
mounted sideways on trussing, or set on a flat level surface. Be sure this fixture is kept at least 12m
(40ft) away from any flammable materials (decoration etc.). ALWAYS use and install a properly rated
safety cable as a safety measure to prevent accidental damage and/or injury in the event the clamp
fails.
Screw one clamp via a M12 screw and nut into the Omega holder. Insert the quick-lock fasteners of
the Omega holder into the matching holes of the adjustable mounting bracket. Tighten the quick-
lock fasteners fully clockwise. Pull the safety-cable through the attachment openings and over the
trussing system or a safe fixation spot. Insert the end in the carabine and tighten the safety screw.
PLEASE REFER TO THE ILLUSTRATIONS ON THE FOLLOWING PAGE.
10