Figure 42: Applilet Ez For Hcd Controller Save File As (Uart0.Xml); Figure 43: Applilet Ez For Hcd Controller Dimmer Program Settings (Serial Command) - NEC 78K0 User Manual

Hide thumbs Also See for 78K0:

Table of Contents

78K0 - Shine It!

Change the dimmer program to "Serial Command". Select UART0 as the interface and

ASCII type.

Make sure to deselect the "All Channel Synchronize" check box. Configure the board into

programming mode (SW1.1 set to OFF) and attached the USB cable. Click the save

button and then click the All P. button.

Remove the USB cable and now change the SW1.4 to ON in order to change the Maxim

RS232/485 device to be in RS232 mode.

Attached the DB9 cable to the board and then apply power to the board.

Open a text terminal application. We will use Windows HyperTerminal as an example. Click

Start → Programs → Accessories → Communications → HyperTerminal.

Enter the connection name "EV-K0-HCD" and click OK.

Figure 42: Applilet Ez for HCD Controller Save File as (uart0.xml)

User's Manual U19610EE3V0UM00

Table of Contents