Exercise 4 - Analog Input Program; Figure 38: Applilet Ez For Hcd Controller Variable Dimmer Control Settings (Set) - NEC 78K0 User Manual

Hide thumbs Also See for 78K0:

Table of Contents

78K0 - Shine It!

Make sure that the EV-K0-HCD board is in programming mode (SW1.1 set to OFF) and the

USB cable is connected correctly. Click the save button and afterwards the All P. button.

After downloading the application disconnect the USB and set the EV-K0-HCD board in the

run mode as described in

running the variable dimming application based on the wave table drawn.

7.4 Exercise 4 – Analog input program

This program controls the duty value for each channel by looking at the A/D conversion result. In order to

perform this exercise you will need to have a 2-pole 100KΩ potentiometer attached the J5 connector which

is the ADC channel 0 of the MCU.

Exercise 2

point 7. You should now see the LEDs on the board

User's Manual U19610EE3V0UM00

Table of Contents