Exercise 3 - Variable Dimmer Program; Figure 32: Applilet Ez For Hcd Controller Start Flash Programming; Figure 33: Applilet Ez For Hcd Controller Flash Programming Status - NEC 78K0 User Manual

78K0 - Shine It!
6. During the flash procedure you will be informed about the actual status of the download
7. Click CLOSE to exit the "Build" window. Remove the USB and change SW1.1 to the on
position for run mode. Insert the power connector or the USB cable to the board and you
should see the LEDs light up to finish this exercise.
I. HP-LED1(channel 1) = Red
II. HP-LED2(channel 2) = Green
III. HP-LED3(channel 3) = Blue
IV. HP-LED4(channel 4) = White
7.3 Exercise 3 – Variable dimmer program
This program sets the duty value for each channel given by drawing pattern data.
1. Make sure that you have set all the settings as explained in
2. Save the new Applilet EZ project name to variable.xml. Select File → Save as.. and input
"variable.xml" and then click Save.

Figure 32: Applilet EZ for HCD Controller Start Flash programming

Figure 33: Applilet EZ for HCD Controller Flash programming status

User's Manual U19610EE3V0UM00
Exercise 1.
34