78K0 - Shine It!
4. Hardware installation
After unpacking the 78K0 Shine it! Starter kit, connect the board via connector CN1 to your host computer
using the provided USB interface cable. When EV-K0-HCD board is connected, the USB driver needs to be
installed on the host machine. Please refer to the following CHAPTER 5 SOFTWARE INSTALLATION.
5. Software installation
The Shine it! package comes with the following software packages:
•
Applilet EZ for HCD Controller
•
IAR Systems Embedded Workbench for 78K 4Kbyte code size limited, including C compiler,
assembler, linker, librarian and IAR C-SPY debugger / simulator
•
Device file package of µPD78F8024 for IAR Embedded Workbench for 78K
•
WriteEZ3 flash programmer including the PRM file for µPD78F8024
5.1 Applilet EZ for HCD Controller installation
To install the Applilet EZ for HCD Controller just press the regarding button from the Autorun of the CD-ROM
provided within the Shine it! package. The setup dialogues will guide you through the installation process.
The installation can also be started by executing the AppEZHCD.msi in the directory "\Applilet" of the
CDROM.
Figure 6: Shine it! CDROM autorun.exe
User's Manual U19610EE3V0UM00
20