Figure 24: Applilet Ez For Hcd Controller Cpu Settings; Figure 25: Applilet Ez For Hcd Uart Settings - NEC 78K0 User Manual

Hide thumbs Also See for 78K0:

Table of Contents

78K0 - Shine It!

In the CPU settings you have to select the Target EV-K0-HCD. Under the clock setting you

can choose between the internal 8 MHz and external clock/oscillator setting. Make sure the

clock is on External 8 MHz and then click OK. Furthermore you can select the active LED

channels.

The uPD78F8024 device contains two UART peripherals. Applilet EZ allows configuration

these peripherals for the simple control programs. We will take a look at UART0. Select

Project → UART0.

In the UART0 setting you can configure the baud rate or "Speed" and the "Parity" type.

Click OK to leave the setting at 9600bps and odd parity.

The Applilet EZ is able to use the NEC Compiler for 78K0 as well as the IAR Embedded

Workbench for 78K. To select click Setting → Compiler and choose the IAR compiler when

using the Applilet EZ for HCD Controller with the Shine It! starter kit.

Figure 24: Applilet EZ for HCD Controller CPU settings

User's Manual U19610EE3V0UM00

Table of Contents