Table of Contents
Advertisement
Change BIOS settings
If the Boot Mode setting is "Legacy", follow the instructions below to change this product's BIOS
settings (registering Boot device and enabling Boot BIOS) after preparations.
1> Confirm that this product is properly connected with the Fiber Channel device. Then, turn on the
computer.
2> Hold <Alt> key or <Ctrl> key and press <E> key while the following message is displayed. Then,
you see this product's BIOS menu.
Emulex LightPulse FC BIOS, Version 2.12a15
Copyright (c) 1997-2014 Emulex. All rights reserved.
Press <Alt E> or <Ctrl E> to enter Emulex BIOS configuration
utility. Press <s> to skip Emulex BIOS
Notice
3> When the computer detects that <Alt> or <Ctrl> and <E> keys are pressed, you see the following
messages and the menu.
Emulex FC BIOS configuration utility selected
Bringing the Link up, Please wait...
1. LPe1250-F8-N: Bus:30 Dev:00 Func:00 WWPN: 10000090FA211128
2. LPe1250-F8-N: Bus:20 Dev:00 Func:00 WWPN: 10000090FA21112A
Without enabled the Option Rom of PCI slot which installed this product, this
message is not displayed. Refer to the computer's User's Guide for how to enable
the Option Rom of PCI slot.
This product's BIOS menu consumes a lot of memories. Therefore, depending
on your environment (for example, an expansion board is consuming a lot of
memories), this menu may not be displayed or you may not be able to change the
settings. In such a case, disable the Option ROM unnecessary on the computer
or take other countermeasures. Refer to the computer's User's Guide for how to
disable the Option ROM.
Emulex LightPulse FC BIOS Utility. OB2.12a15
This utility displays and saves changes when selected.
You will be prompted to reboot for all changes to take effect.
Emulex FC Ports in the System:
Enter <Esc> to exit <PageDn> to Next Page
<↑/↓> to Highlight, <Enter> to Select
Copyright (c) 1997-2014 Emulex. All rights reserved.
- 64 -
Advertisement
Table of Contents
