Advertisement
6. Using a Mains Adapter
7. Error Messages
8. Safety, Care, Accuracy Test and Disposal
• Safety and protection
• Device care
• Cleaning the cuff
• Accuracy test
• Disposal
9. Guarantee
10.Technical Specifications
1. Using the Device for the First Time
Inserting the batteries
After you have unpacked your device, first insert the batteries. The
battery compartment 7 is on the bottom of the device. Insert the
batteries (4 x 1.5 V, size AA), thereby observing the indicated polarity.
Setting the date and time
1. 1. After the new batteries are fitted, First the MAM-iconBL
( flashes in the display, You can set ON/OFF by pressing the
M-button 3, press the Time button 4 to confirm, Then the
year number flashes in the display. Set the year by pressing
the M-button 3. To confirm and then set the month, press the
Time button 4.
2. Press the M-button to set the month. Press the time button to
confirm and then set the day.
3. Follow the instructions above to set the day, hour and minutes.
4. Once you have set the minutes and pressed the time button, the
date and time are set and the time is displayed.
5. If you want to change the date and time, press and hold the
Time button for approx. 3 seconds, you need confirm MAM
mode first and then you can enter the new values of date and
time as described above.
Selecting the correct cuff
Microlife offers different cuff sizes. Select the cuff size to match the
circumference of your upper arms (measured by close fitting in the
centre of the upper arm).
Cuff size
for circumference of upper arm
S
17 - 22 cm
M
22 - 32 cm
M - L
22 - 42 cm
L
32 - 42 cm
L - XL
32 - 52 cm
2
Pre-shaped cuffs are optionally available.
Only use Microlife cuffs.
Contact your local Microlife Service if the enclosed cuff 8 does not
fit.
Connect the cuff to the device by inserting the cuff connector 9 into
the cuff socket 5 as far as it will go.
The device allows to store the results for individual users. Select
the intended user (user 1 or user 2 BM) by pressing the Time
button 4.
Before each measurement, ensure the correct user is selected.
Before each measurement, select standard (single measurement)
or MAM mode (automatic double measurement). In MAM mode, 2
measurements are automatically taken in succession and the
result is then automatically analysed and displayed. Because the
blood pressure constantly fluctuates, a result obtained in this way
is more reliable than when a single measurement is performed.
• To select MAM mode, press and hold the Time button 4 for
approx. 3 seconds, The LCD will display MAM icon and flashes
ON (means enter the MAM mode). To change to standard mode
(single measurement), press the M-button, until the ON turn to
OFF (means single measurement), press the Time button 4 to
confirm.
• The bottom, right hand section of the display shows a 1 or 2 to
indicated which of the 2 measurements is currently being taken.
• There is a break of 15 seconds between the measurements. A
count-down indicates the remaining time.
• The individual results are not displayed. Your blood pressure
will only be displayed after all measurements are taken.
• Do not remove the cuff between measurements.
• If one of the individual measurement was questionable, an
additional measurement is automatically taken.
Advertisement
