Module Start-Up; Equipment Needed - Emerson PACSystems IC695CPE400 Quick Start Manual

Module Start-up

Equipment Needed

This PACSystems Rackless RX3i CPU.
▪
A compatible SELV 24Vdc, 48W power supply (72W if Energy Pack
▪
attached).
(Optionally) A compatible Energy Pack, IC695ACC403, and corresponding
▪
cable.
If no Energy Pack is to be attached, use the power supply cable described in
▪
section Connect to Power Supply. Otherwise, refer to PACSystems RX3i
Rackless Energy Pack IC695ACC403 Quick Start Guide, GFK-3000.
A DIN rail, typically mounted in an enclosure, as discussed above.
▪
Alternately, mount the unit using the compatible panel-mount adaptor.
A computer running Web Browser to access PACEdge and PAC Machine
▪
Edition™ (PME) configuration and programming software. PME Version 9.70
SIM 16 or later supports the CPL410/CPE400. Version 9.50 SIM 5 is required
for Hot Standby Redundancy.
Ethernet cable for connecting the PME programmer computer to the
▪
CPL410/CPE400.
Additional cables, as needed, to connect each port employed in the
▪
application.
A very small, slotted screwdriver to secure the 24 Vdc mating connector.
▪
A T8 Torx screwdriver, if the micro-SD slot cover is to be removed. Note that
▪
the cover must be replaced to achieve immunity from electrical noise.
A T10 Torx screwdriver, if exchanging the mounting adaptors.
▪
17 Rackless CPU w/PACEdge Quick Start Guide GFK-3053G