Displays and Indicators (LEDs)
OLED Display
The monochrome organic light-emitting diode (OLED) display is used to
display CPL410/CPE400 system menus. It interacts with the DISP
pushbutton, which jogs the cursor from one menu item to the next, and
with the SEL pushbutton, which activates the currently indicated menu item
for further action.
The OLED display permits the user to:
Display Ethernet LAN Settings: IPv4 address.
▪
Display the PLC firmware revision.
▪
Set/view PLC mode and view sweep time.
▪
Set the PLC mode to RUN/STOP with I/O Enabled/Disabled via the display.
▪
Note: the RUN and STOP pushbuttons activate the PLC Mode menu items
per section switches.
View whether all, some, or none of the PROFINET I/O devices are connected.
▪
Display PACEdge Settings: IPv4 address, subnet mask, gateway, MAC
▪
address, IPv6 address.
Issue PACEdge Commands
▪
Configuration, Perform factory reset.
View HSB Redundancy Mode and State (Release 9.30 and later)
▪
Command an HSB Redundancy Role Switch (Release 9.30 and later)
▪
4
:
Enter/Exit Configuration mode, Clear
Rackless CPU w/PACEdge Quick Start Guide
GFK-3053G