Interfaces And Connectors; Usb Ports; Front-Panel Ethernet Ports - Emerson PACSystems IC695CPE400 Quick Start Manual

Interfaces and Connectors

USB Ports

On the front panel CPL410/CPE400 features 2 USB 3.0 ports, labeled USB1
and USB2.
•
USB1 is assigned to PACEdge and can be used for storage devices.
For other USB devices an appropriate Linux driver will need to be
installed.
•
USB2 is assigned to the Controller run time PACS.

Front-Panel Ethernet Ports

LAN1 connects to the uppermost RJ45 connector. It is not switched.
LAN2 connects to the middle two RJ45 connectors. These two ports are
switched internally.
LAN3 connects to the two lower RJ45 connectors. These two ports are
switched internally. LAN3 may only be used to supply a high-speed
synchronization link between the Primary and Secondary CPUs in Hot
Standby Redundancy. Both ports are typically used, as described in the
PACSystems Hot Standby CPU Redundancy User Manual, GFK-2308 (revision L
or later).
Each of the embedded Ethernet interfaces automatically senses the data
rate (10 Mbps or 100 Mbps or 1 Gbps), communications mode (half-duplex
or full-duplex), and cabling arrangement (straight-through or crossover) of
the attached link. LEDs embedded in each RJ45 connector provide
indications per the table above.
LAN1 or LAN2 may be used to communicate with the PME programming
software using the Service Request Transport Protocol (SRTP).
8 Rackless CPU w/PACEdge Quick Start Guide GFK-3053G