Assembly; Attach The Vertical Rails - StarTech.com PORACK12U Manual

Assembly

To make the assembly easier to complete, consider assembling the PORACK12U with
another person's assistance.

Attach the vertical rails

1. If the security plate is attached, unscrew the thumbscrews from the front of the
security plate and remove it from the sliding tray.
2. Position one of the vertical rails near one of the front corners of the sliding tray.
3. Insert two of the assembly screws through the square-shaped holes on the side
of the vertical rail and the sliding tray.
4. Screw an assembly nut onto each of the assembly screws.
5. Repeat steps 1 to 4 to attach three of the vertical rails to the sliding tray.
6. Position one of the vertical rails near one of the back corners of the sliding tray.
7. Insert an assembly screw through the lower square-shaped hole on the side of
the vertical rail and the sliding tray.
8. Screw an assembly nut onto the assembly screw.
9. Insert an assembly screw through the U hole in the vertical rail and the sliding
tray.
10. Screw an assembly nut onto the assembly screw.
11. Repeat steps 6 to 10 to attach a vertical rail on the other back corner of the
sliding tray.
Instruction manual
8