ADF Web HD67694-IP-B2-1-10 User Manual page 17

Industrial Electronic Devices
M-BUS
By pressing the "M-Bus" button from the main
window for SW67694 (Fig. 2) the window "M-
Bus" appears (Fig. 4).
In this section, it is possible to select the
converter type and the list of nodes/variables of
M-Bus side.
The means of the fields are:
In the field "Select
converter used is defined;
In the field "Select Template" the M-
Bus controller connected is defined;
In the field "Description" a description
for the node is defined;
In the field "M-Bus ID
of polling (by Primary or Secondary
Address) is defined;
In the field "M-Bus ID" the ID of the M-
Bus controller is defined;
If the field "Node State" is checked, the
Status of the controller is mapped on
Modbus side;
If the field "Identification
In the field "MSB (xx)" the first part of the description of the M-Bus variable is defined;
In the field "SST (yy)" the second part of the description of the M-Bus variable is defined;
In the field "Third Field
After that, pressing the "ADD" button, a new node appears in the "List of M-Bus Devices" table. In order to modify a created node it is
necessary to select the desired node, change the wrong items and then press the "MODIFY" button.
ADFweb.com S.r.l.
Converter" the
Type" the type
Figure 4: "M-Bus" window
Number" is checked, the Secondary Address of the M-Bus controller is mapped on Modbus side;
(zzz)" the third part of the description of the M-Bus variable is defined.
User Manual M-Bus / BACnet/IP
Document code: MN67694_ENG Revision 1.000 Page 17 of 25