Additional Information; Io-Link Overview; Io-Link V1.1 Profile And Models; Hardware Interface - Banner A-GAGE EZ-ARRAY Instruction Manual

® ™
A-GAGE EZ-ARRAY with IO-Link v1.1

6 Additional Information

6.1 IO-Link Overview

For the latest IO-Link protocol and specifications, please visit the web site at
IO-Link is a point-to-point communication link between master and slave. It can be used to automatically parameterize
sensors and transmit process data.

6.2 IO-Link v1.1 Profile and Models

Parameter
IO-Link revision
Process Data In length
Process Data Out length
Bit Rate
Minimum cycle time
Device ID

6.3 Hardware Interface

IO-Link is designed around IEC 61131-9 Single-drop digital communication interface for sensors and actuators (SDCI). The
figure below shows the SDCI connection for 3-wire connection devices. Power, ground, communication, and/or switching
signal are required, pin 2 is an optional I/O. The EZ-ARRAY provides the SDCI connection with an IO-Link cable splitter
accessory. The EZ-Array is a Port Class A device.

6.3.1 Electrical Interface

IO-Link Splitter CSB-M1240M1280 (Dual Discrete) Pinouts
Connector #1
EZ-ARRAY 8-
Pin Connector
1 2
2 8
3 7
4 3
24
Value
V1.1
240-bit
None
38,400 bps
18 ms
65550
8-Wire Signal Definition
Cable
Brown L+ 18-30 VDC
Red Q Switching Signal
D02
Blue L- 0 VDC
Green Q Switching Signal
DO1 (SIO)
www.bannerengineering.com - Tel: + 1 888 373 6767
http://www.io-link.com
Parameter
Port class
SIO mode
Smart sensor profile
Block parameterization
Data Storage
ISDU Supported
CSB-M1250M1280 (Analog) Pinouts
EZ-ARRAY 8- 8-Wire
Pin Connector Cable
2 Brown
1 White
7 Blue
3 Green
Value
A
Yes
No
No
Yes
Yes
Signal Definition
L+ 18-30 VDC
AO V Out 1 (0-10V)
L- 0 VDC
Q Switching Signal DO1
(SIO)