System Components; Models; Status Indicators - Banner A-GAGE EZ-ARRAY Instruction Manual

2.1 System Components

A typical A-GAGE EZ-ARRAY has four components: an emitter
and a receiver, each with an integral quick-disconnect (QD) fitting,
plus an 8-pin QD cordset for the emitter and for the receiver.
For applications that use the IO-Link interface, an additional cable
splitter is used to convert the receiver 8-pin connector to a
compatible M12 connector.

2.2 Models

Emitter
EA5E150Q EA5R150XK2Q
EA5E300Q EA5R300XK2Q
EA5E450Q EA5R450XK2Q
EA5E600Q EA5R600XK2Q
EA5E750Q EA5R750XK2Q
EA5E900Q EA5R900XK2Q
EA5E1050Q EA5R1050XK2Q
EA5E1200Q EA5R1200XK2Q
EA5E1500Q EA5R1500XK2Q
EA5E1800Q EA5R1800XK2Q
EA5E2100Q EA5R2100XK2Q
EA5E2400Q EA5R2400XK2Q

2.3 Status Indicators

Both the emitter and receiver provide ongoing visual indication of operating and configuration status.
The emitter has a red LED that signals proper operation (ON when power is applied).
2 Discrete Output 1 is push-pull (IO-Link)
3 Models with array lengths 1050mm and longer ship with a center bracket as well as two end-cap brackets.
Receiver with IO-Link Receiver Discrete Output
v1.1
www.bannerengineering.com - Tel: + 1 888 373 6767
Receiver Analog
2
Output
PNP Voltage (0-10 V)
PNP Voltage (0-10 V)
PNP Voltage (0-10 V)
PNP Voltage (0-10 V)
PNP Voltage (0-10 V)
PNP Voltage (0-10 V)
PNP Voltage (0-10 V)
PNP Voltage (0-10 V)
PNP Voltage (0-10 V)
PNP Voltage (0-10 V)
PNP Voltage (0-10 V)
PNP Voltage (0-10 V)
® ™
A-GAGE EZ-ARRAY with IO-Link v1.1
Figure 3. Components
Array Length Y 3
150 mm (5.9 in)
300 mm (11.8 in)
450 mm (17.7 in)
600 mm (23.6 in)
750 mm (29.5 in)
900 mm (35.4 in)
1050 mm (41.3 in)
1200 mm (47.2 in)
1500 mm (59.1 in)
1800 mm (70.9 in)
2100 mm (82.7 in)
2400 mm (94.5 in)
Total
Beams
30
60
90
120
150
180
210
240
300
360
420
480
5