Advertisement
GreyT Telescope - User Guide
(Rev 1)
Tube Hole Patterns
The holes in the bottom of the Base Tube and top of the Intermediate/Base Tubes
are used to pin the Top Blocks and Gearbox to their respective tubes. The holes in the
bottom of the Intermediate Tube are used to install the Bottom Blocks, Hardstops, and
CF Springs to their respective tubes. The top of the output tube will be determined by
the user. This is the recommended spot for the Telescope String to anchor to, as it is the
easiest place to do so.
Note: An easy way to anchor the string to the output tube is to drill a 3/8" hole in the
end of the tube and run a 3/8" OD shaft through for the string to be tied to.
Table of Contents
Page 7
wcproducts.com
Advertisement
