Advertisement
GreyT Telescope - User Guide
(Rev 1)
Telescope - Step 1
Slide the Base Tube for your Telescope into the gearbox. In order to do this, loosen all
bolts and remove all #10-32 x 3/8"L bolts. The 4 holes in the Base Tube will align with the
holes for the #10-32 x 3/8"L bolts. Once the Base Tube is in Place, thread the #10-32 x
3/8"L bolts back in. These bolts should sit in the holes in the Base Tube and act as pins
to prevent the tube from moving. Re-tighten all other bolts.
Note: For the Flipped Gearbox configuration, the Base Tube will be slid in from the
opposite side�
Table of Contents
Page 33
wcproducts.com
Advertisement
