Advertisement
GreyT Telescope - User Guide
(Rev 1)
Gearbox - Step 10 (Continued)
To mount the Ratchet & Pawl, first drill and tap to 5/16-18 the hole the Pawl mounts to.
Then mount the Ratchet & Pawl using the parts shown in the image down below. Finally,
drill out the mounting hole at the end of the piston with a #18 drill bit and mount the
piston once everything else is in place.
Note: This step can be skipped if you plan on using the Telescope without the Ratchet
& Pawl or WCP Friction Brake�
Note: Piston and #8-32 x 1"L Bolt are not sold by WCP�
Table of Contents
Page 30
wcproducts.com
Advertisement
