Advertisement
GreyT Telescope - User Guide
(Rev 1)
Gearbox - Step 2
These bearings will be a light press fit and may be pressed in by hand or with an arbor
press. The image below shows the side the bearings must be installed from for all
configurations of the Telescope Gearbox.
If you plan on assembling the Gearbox with the Ratchet & Pawl, the hole marked in green
in the image below must be tapped to 5/16-18. Otherwise, that hole can be left alone.
Note: If you do not plan on assembling the Gearbox with either the Ratchet & Pawl or
WCP Friction Brake, you may omit the 1/2" Hex ID x 1-1/8" OD Flanged Bearing boxed
in blue in the image down below�
Table of Contents
Page 17
wcproducts.com
Advertisement
