Advertisement
GreyT Telescope - User Guide
(Rev 1)
Gearbox - Step 7
Bolt the two halves of the Gearbox together using the #10-32 x 1-3/4"L bolts. The image
down below shows the bolt locations marked out in green.
Note: If you are assembling either the Flipped or Non-Flipped configurations of the
1-1/2" Base Gearbox, you can omit the 1/8"L spacers. For those configurations of the
Telescope, those bolts will act as pins that hold the 1-1/2" Base Tube in place�
Table of Contents
Page 22
wcproducts.com
Advertisement
